・If this is your first time applying the product, be sure to carefully read the attached application instructions before beginning.
・For areas where application with a roller is difficult, such as inside corners, use a brush or paint applicator to achieve a clean finish down to the finest details.
・Avoid application when the outside temperature or substrate temperature is 5°C or lower, or when humidity is 85% or higher.
・If condensation forms on the paint film during the drying stage, it may cause stains or blotches; therefore, exercise caution when applying the product during winter or in rainy weather.
・When storing the material, protect it from direct sunlight and freezing, and avoid storing it at low temperatures (below -5°C) or high temperatures (above 40°C).
・Plaster is an air-hardening material that absorbs carbon dioxide to harden. To ensure proper curing, ensure good ventilation during and after application.
・Combining this product with materials from other manufacturers may result in issues such as poor adhesion or failure to achieve adequate coating performance.
・We recommend using a medium-pile roller (20 mm) that holds paint well and has good body. (Reference: PIA Co., Ltd., “Joker” 20 mm pile)
・For wooden substrates or renovation projects, apply a tannin-blocking sealer first, followed by MILIME’s dedicated substrate primer. (Please note that plaster is more prone to resin bleed than general-purpose paints, so apply with care.)
・Since this is a natural material, slight color variations may occur between batches.
・Plaster is strongly alkaline. When handling it, take care to avoid skin contact as much as possible and wear protective gear as necessary. In the unlikely event that it gets into your eyes, do not rub them; rinse immediately with running water and seek medical attention right away.
・Please refer to the SDS for other precautions.
